Skip to content

Compare two dates

Put two satellite images of a field side by side, or map the difference between them, to see where the crop changed.

Last reviewed November 2, 2026

Compare puts two satellite images of the same field next to each other, called A and B. Use it to see where the crop changed between two dates, for example after a storm, an irrigation fault or a treatment.

Open Compare

  1. Open the field and go to the Satellite tab.
  2. Select Compare at the top of the map, or Compare in the switch.

Compare opens with the image on screen as A and the clear image before it as B. You can also open it from the chart over time with Compare two dates, or from a satellite alert with See the change.

While the field has only a single image, the button stays grey and says Compare needs at least two image dates.

Choose the dates and the index

A and B each have their own date control, with arrows and a calendar, as on the map. They can't show the same date, so B's arrows and calendar skip the date shown as A.

The index menu sets the index for both images. Swap A and B turns A into B and B into A.

Swipe between the images

  1. Choose Swipe.
  2. Drag the divider on the map to uncover more of A or more of B.
  3. Select Show A or Show B to see one image whole.

Map the difference

  1. Choose Difference. It is greyed out when the index is true colour, or when too little of the field is clear on both dates. Then only Swipe is available.
  2. The map colours each part of the field by how much its value changed. The legend, Difference A − B, runs from Decline through No change to Increase.

The difference is A minus B. With the newer image as A, an increase means the value went up since B.

A card in the panel sums up the change:

  • Mean change and Median change for the whole field;
  • how much of the field fell or rose by more than a small margin;
  • Compared area, the share of the field that was clear on both dates. Only that part is compared.

To check one spot, use Inspect a point. The reading shows the value on A, the value on B and the change.

When you have seen what changed

Under the comparison, Next steps offers Add an observation. It opens a new observation for this field in the field logbook. Once you save it, you are back at the comparison.

Select Close compare to go back to the single image.

Common problems

  • Clouds on one of the dates. Too few clear pixels on both dates to show a difference. Use Swipe or pick other dates. If only part of the field is clear on both dates, Compare warns you to read the difference with care.
  • The difference doesn't load. The difference image could not be loaded. Use Swipe or try again later.
  • The field is under plastic or netting. Compare shows true colour images only, side by side with Swipe. There is no index menu and no Difference. The comparison says Under plastic or netting, only the true-colour images can be compared. See Greenhouses and covered fields.
  • You're offline. Comparison figures need a connection.

Still stuck?Email support.truleaf@truleaf.org